Abstract

BackgroundTo explore the impact of preoperative 3D printing on the fixation of posterior rib fractures utilizing a memory alloy embracing device of rib under thoracoscopy.MethodsThe enrolled patients were divided into the 3D printing (11 patients) and the non-3D printing (18 patients) groups, based on whether a 3D model of ribs was prepared prior to surgery. Analysis was conducted comparing the average fixation time per fracture, postoperative fixation loss, and poor reduction of fractured end between the two groups.ResultsThe average fixation time of each fracture was 27.2 ± 7.7 min in the 3D printing group and 29.3 ± 8.2 min in the non-3D printing group, with no statistically significant difference observed between the two groups (P > 0.05). The incidence of poor fracture fixation in the 3D printing group was statistically lower than that in the non-3D printing group (12.9% vs. 44.7%, P < 0.05). Further stratified analysis revealed that the off-plate rate in the 3D printing group and the non-3D group was (3.2% vs. 12.8%, P > 0.05), and the dislocation rate of the fractured end was (9.7% vs. 31.9%, P < 0.05).ConclusionsThe application of 3D printing technology to prepare the rib model before surgery is proves beneficial in reducing the occurrence of poor fixation of fractures and achieving precise and individualized treatment.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.