Abstract
Plastic is one of the most widely used raw materials for a product. Human life cannot be separated from products or equipment made from plastic. Company X often has problems with the quality of the products produced, especially valve products as products that are produced every day. The corrective step used to assist Company X in improving the quality of valve products is the application of the PDCA method. PDCA method consists of the plan, do, check, and act stages. The proposed improvement design was carried out based on the results of data processing and obtained as many as 9 proposed improvements. In the do stage, implementation of the proposed improvements that have been designed is carried out, five proposed improvements can be implemented and the other four in the form of recommendations. Next is the check stage, which is the process of collecting data again on the results of the implementation of the proposed improvement. Based on the results of the check stage, a standardization process was carried out at the act stage to improve the performance of the proposed improvement and the quality of the valve product. Standardization is done by changing or improving the proposed improvements that have been implemented. Research has succeeded in reducing the number of defective valve products with the proportion of defects that were previously 1.16% to 0.57%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.