Application of microwave heating to the determination of free, combined and total sulphur in rubber

Abstract

An atomic absorption spectrometry (AAS) method for the determination of total and combined sulphur in rubber and a catalytic method for the determination of free sulphur in rubber are described. The catalytic method is based on the iodine-azide reaction and is followed by an extraction of free sulphur with benzene, toluene or acetone. The catalytic determination, with the aid of gas chromatography, was performed in N, N-dimethylformamide after expelling the more volatile solvents used in the extraction. The calibration is linear over the range 2 × 10 −6 – 3 × 10 −4 M. Before the determination of total and combined sulphur, the rubber samples were decomposed by microwave assisted heating (5 min, 110 W) in a Teflon closed vessel. After microwave heating the solution was clear and homogenous and all sulphur compounds contained in the rubber were quantitatively oxidized to sulphate. The sulphates were then precipitated as BaSO 4 and an excess of barium was determined by AAS. From the difference in the results of the determinations of total and free sulphur the amount of combined sulphur can be calculated, and from the difference in the determinations of total and combined sulphur the amount of free sulphur can be calculated. In the latter case the catalytic analysis is not needed.