Application of graphene‐based adsorbents in the treatment of dye‐contaminated wastewater; kinetic and isotherm studies

Abstract

AbstractThe adsorption of methylene blue (MB) on graphene‐based adsorbents was tested through the batch experimental method. Two types of graphene‐based adsorbents as graphene oxide (GO) and reduced graphene oxide (RGO) were compared to investigate the best adsorbent for MB removal. So that optimizing the MB removal for the selected type of graphene‐based adsorbent, the diverse experimental factors, as pH (2–10), contact time (0–1440 min), adsorbent dosage (0.5–2 g/L), and initial MB concentration (25–400 mg/L) were analyzed. The conclusions indicated that the MB removal rised with an increase in the initial concentration of the MB and so rises in the amount of adsorbent used and initial pH. Maximum dye removal was calculated as 99.11% at optimal conditions after 240 min. Adsorption data were compiled by the Langmuir isotherm (R2: 0.999) and pseudo‐second‐order kinetic models (R2: 0.999). The Langmuir isotherm model accepted that the homogeneous surface of the GO adsorbent covering with a single layer. And the adsorption energy was calculated as 9.38 kJ mol−1 according to the D‐R model indicating the chemical adsorption occurred. The results show that GO could be utilized for the treatment of dye‐contaminated aqueous solutions effectively.