Application of different numerical models capable to simulate combustion of alternative fuels in internal combustion engine

Abstract

PurposeThe internal combustion engine operated on gaseous fuels shows great potential in terms of integration of the renewable and traditional sources for an effective solution for clean energy production challenge. Different fuel mixtures that can be used to power the engine are characterized by various combustion properties, which can affect its overall efficiency. The purpose of this paper is to provide reasonable answer, how the operation condition can change due to different fuel, without enormous cost of prototyping processes using physical models a digital model can be seen as promising technique.Design/methodology/approachPresented work discusses the application, and extensive description of two commercial codes Ansys Fluent and Forte for modeling stationary engine fueled by compressed natural gas (CNG) and biogas. To check the model accuracy, all carried out numerical results were compared against experimental data collected at in-house test rig of single cylinder four stroke engine. The impacts of tested gaseous fuel on the engine working conditions and emission levels were investigated.FindingsCarried out simulations showed good agreement with experimental data for investigated cases. Application on numerical models give possibility to visualize flame front propagation and pollutant formation for tested fuels. The biogas fuel has shown the impaired early flame phase, which led to longer combustion, lower efficiency, power output, repeatability and in some cases higher HC and carbon monoxide (CO) emissions as a result of combustion during the exhaust stroke. Looking at the CO formation it was observed that it instantly accrue with flame front propagation as a result of methane oxidation, while for NOx formation revers effect was seen.Originality/valueThe application of new approach for modeling combustion process in stationary engines fueled by CNG and alternative biogas fuel has been discussed. The cons and pros of the Forte code in terms of its application for engine prototaping process has been discussed.