Abstract
The application of computer simulation technology in engineering design and analysis fields can effectively reduce product production cost, and improve the design efficiency. Through the computer simulation analysis of the key structure of gilling machine, the maximum stress value and its position of the working screw can be obtained in the working condition when roller’s linear velocity are at 1st and 2nd gear ratio, respectively, about 66.0m/min and 57.0m/min. In addition, in the assembly model simulation analysis of gilling machine structure, the influence of prestress simulation is considered and obtained the first 4 order’s natural frequencies and mode shapes in two kinds of gear ratios in those working conditions. It provides some suggestions that can be used to research the effect factors of gilling machine design, the gilling machine structure optimization and operating mode control.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
