Application of CO2-Laser Micro-Perforation Technology to Freeze-Drying Whole Strawberry (Fragaria ananassa Duch.): Effect on Primary Drying Time and Fruit Quality.

Abstract

Freeze-drying (FD) processing preserves foods by combining the most effective traditional technologies. FD conserves the structure, shape, freshness, nutritional/bioactive value, color, and aroma at levels similar to or better than those of refrigerated and frozen foods while delivering the shelf-stable convenience of canned/hot-air-dehydrated foods. The mass transfer rate is the essential factor that can slow down the FD process, resulting in an excessive primary drying time and high energy consumption. The objective of this study was to reduce the FD processing time using CO2 laser technology to improve product competitiveness in the preservation of whole strawberries. The research process consisted of the selection and characterization of fresh strawberries, followed by preparation, pre-treatment, freeze-drying, a primary drying time assessment, and a quality comparison. Experiments were carried out using strawberries without micro-perforation and with five and eight micro-perforations. Quality parameters were determined for fresh, frozen/thawed, and freeze-dried/rehydrated strawberries. It was found that the primary drying time can be significantly reduced by 20% (95% CI) from 26.7 h for non-perforated fruits to 22.3 h when five micro-perforations are made on each strawberry. The quality parameters used to evaluate the strawberries did not show significant differences when comparing frozen/thawed fruits with freeze-dried/rehydrated fruits. The experiments conducted in this study showed that freeze-drying may efficiently compete with freezing technology when processing whole strawberries.