Abstract
This paper describes the use of a digital control computer to supervise and control the process on-line in certain important areas. Among the functions covered are: priority scanning of critical points including off-limit checking; primary raw material control; final raw material control through the raw grinding and homogenizing systems; rotary kiln control including cold start-up procedures; and automatic calculation and typeout routines for production log, chemist's log, and alarm log. Electronic instrumentation and control with computer operated set point provides the basic level of control. This is fully coordinated with the computer, which provides automatic continuous supervisory and documentary functions. Some comments are given on sixteen months of operating experience.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Industrial Electronics and Control Instrumentation
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
