Applicability of single sample method to test strength parameters of sandstone

Abstract

The single sample method allows the mechanical parameters of rocks to be obtained with very few rock samples; however, the method has not been widely used. This is mainly because the yield point of the single sample method is more difficult to control than the conventional triaxial compressive test and the effect of the different control methods on the measured data is not well understood. The single sample method obtains the strength parameters of the rock by loading a single rock sample with multiple stages of confining pressure. Multistage loading tests are divided into peak strength control and long-term strength control according to yield point control. In this study, multistage loading tests of sandstone were carried out to obtain strength parameters using long-term strength control. The results show that sandstones undergo seriously brittle damage in conventional triaxial compressive tests. Although the sandstones have been rigorously selected, they still vary considerably, and long-term strength points are more difficult to control. The error of strength parameters of sandstone obtained using the single sample method may exceed 20% compared to those obtained by conventional triaxial compressive tests. So this method must be used with caution for sandstones.