Abstract
An exponential type creep equation has been developed for heat resistant steels by the authors. This equation was induced assuming both a thermally activated process for a mobile dislocation and rather high applied stress. The applicability of the new creep equation was examined for a pure iron, two kinds of Ni-base super alloys and an eutectic solder alloy in a Pb–Sn system which were tested at relatively high temperatures and under very low stresses. All of the data obtained were completely explained by the new creep equation. The data for each alloy were classified into a few groups, where a deformation mechanism may be different with each other. The new creep equation is valid for stresses higher than the half value of the slope in a logarithm of time to rupture vs. linear stress diagram.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
