Apatite formation on/in hydrogel matrices using an alternate soaking process: II. Effect of swelling ratios of poly(vinyl alcohol) hydrogel matrices on apatite formation

Abstract

In our previous study, we reported a novel method of apatite formation on/in a three-dimensional hydrogel matrix. Using this method, bone-like apatite could be formed on/in the hydrogel matrix under normal conditions in vitro. A poly(vinyl alcohol) (PVA) gel was used as a model matrix. The method consists of two steps: first, water is transformed in a PVA gel with a CaCl2/Tris-HCl aqueous solution (pH 7.4) and second, the gel is soaked in a Na2HPO4 aqueous solution. In the present study, we report a detailed study of the effects of the swelling ratios of PVA gels on apatite formation. Cross-sectional observations and gravimetric measurements of PVA gels with various swelling ratios were done. The amount of apatite formed on/in PVA gels increased almost linearly with an increase in the reaction cycles. The rates of apatite formation on/in PVA gels largely depended on the swelling ratios, which were approximately 0.48, 0.61, 1.28, and 1.55 mg per cycle for swelling ratios of 4.1, 10.4, 16.8, and 30.1, respectively. The apatite content in PVA-apatite composites that was obtained by this method also increased with an increase of the reaction cycles. After six reaction cycles, a PVA gel with a high swelling ratio contains approximately 70 wt% of formed apatite in the composite. On the other hand, a gel with a low swelling ratio contains about 15 wt% of formed apatite in the composite. Cross-sectional views of the PVA gels after each cycle showed that apatite crystals were formed, not only on the surface of the gel but also within it after fifteen reaction cycles. The hydrogel-apatite composites that were obtained using an alternative soaking process will be useful as not only bone substitute materials but also as soft tissue adhesive materials.