Aortic tortuosity index as a predictor of type A aortic dissection

Abstract

Abstract Introduction The risk ok type A aortic dissection (AAD) depends on the degree of aortic wall's alteration, which can result in dilatation or tortuosity. The estimate of this risk relies solely on the evaluation of the diameter of the ascending aorta. Purpose The purpose of this study is to evaluate the presence and importance of aortic tortuosity in patients with type A aortic dissection. Method Postoperative CT scans of patients with type A aortic dissection were compared with CT scans from controls matched for gender and age. After 3D reconstruction, total length (actual distance along aortic center line = Ltot) and geometric length (length of a straight line between start and end of the aortic segment = Lgeo) were measured to calculate the tortuosity index (TI = Ltot / Lgeo). Results Ltot, Lgeo and TI from different aortic segments of the AAD group were higher than in the control group. Ltot and TI of the whole aorta (from aortic valve to bifurcation) were greater in patients with type A aortic dissection (527.7±46.1 mm vs. 475.8±39.7, p<0.0001; and 2.05±0.24 vs. 1.98±0.21, p=0.002 respectively). Total length and TI were greater after exclusion of the ascending part, and a value of this TI >1.3 identifies AAD patients with an accuracy of 74.8% (AUC = 0.792, p<0.0001). TI is altered by risk factors for aortic dissection: it increases with hypertension and age but not by tobacco use, and TI decreases in diabetes. Conclusions Type A aortic dissection is associated with longer aorta and increased aortic tortuosity. This index may help recognize patients at risk for type A aortic dissection. Calculation of tortuosity indexes Funding Acknowledgement Type of funding source: None