Abstract
This paper studies the antimony spreading and segregation that occurred along with the oxidation and solid-state reactions in the Fe2O3-Sb2O3 system. XRD, SEM, TG-DSC and particularly XPS were employed for characterizations. Sb2O4 and FeSbO4 are the only new phases detected. The formation of FeSbO4 is a more exothermic but slower reaction than oxidation of Sb2O3. A mechanical grinding of Sb2O3 and Fe2O3 leads to a significant dispersion of Sb2O3 possibly because of its low hardness. Dispersion of reference Sb2O4 in this way is negligible. During the heating of a mixture of Sb2O3 and Fe2O3 with an atomic ratio of Sb/Fe = 0.5 at 200-1000 degrees C in ambient air, the thermal spreading of Sb2O3 onto Fe2O3 increases with increasing temperature until Sb2O3 is oxidized into Sb2O4. The surface atomic ratio of Sb/Fe measured by XPS, R(Sb/Fe), reaches a maximum around 400 degrees C. The complete oxidation of Sb2O3 leads to a decrease in R(Sb/Fe) because of poorer dispersibility of Sb2O4. The formation of FeSbO4 starting at ca. 800 degrees C causes a further decrease in R(Sb/Fe), but the R(Sb/Fe) is still 3.2 times the nominal bulk Sb/Fe ratio when the Sb2O4 is completely transformed into FeSbO4.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.