Abstract
The utilization of anodized aluminum (Al) components would contribute greatly to combat against dry friction if good tribological properties could be attained. Despite its hardness, the wear rate of anodic coatings presents a major problem in many applications, including automotive, aerospace and high-tech industries. Recently, nanolayers of Ti demonstrated high tribological effectiveness and unusually low dry friction on anodic coatings. However, few researchers focus on the tribological characterization of nanolayers of other elements. In this study, nanolayers of Ti, Zr, Hf, Cu, Cr, Nb and Sn were deposited on anodized 1050 and 6082 alloys by magnetron sputtering and Atomic Layer Deposition. Major attention was devoted to surface roughness and hardness measurements, because of their importance for static friction. The results showed that structural, chemical and other intrinsic properties of nanolayers of Group IVB elements in many cases led to significant friction reduction, when compared to those of Cu, Cr and Hf. Nanolayers of 15 nm to 75 nm thicknesses appeared most effective tribologically, while 180 nm or thicker layers progressively lost their ability to sustain low dynamic friction. Deposition of nanoscale structures could provide advantages for the anodized Al industry in protection against incidental friction and wear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
