Anthropometric measurements of patellar ridge using computed tomography-based three-dimensional computer models

Abstract

BackgroundThe objectives of this study were to investigate the anatomic morphology of patellar ridge using computed tomography-based three-dimensional (3D) computer models and to assess the center of the patellar ridge after virtual resections.MethodsWe selected 80 patients, 40 males (age, 33.2±6.8 years) and 40 females (age, 30.6±7.2 years), who were slightly symptomatic with soft tissue injury of the knee joint. The right or left knees were scanned by computed tomography (CT). The CT data of 160 knees was used to construct 3D computer models by image analysis software (Mimics). Variables such as the angle between the patellar ridge and patellar long axis, the distance between the center of the patellar ridge and the center of patellar cut after virtual resections were measured. We detect differences between the sides and genders with the 3D computer models by Student’s t test. Simple linear regression and correlation test was used to correlate the patellar ridge center to the center of the patellar cut.ResultsAccording to the available data, there were significant gender differences in the length and width of patellar cut after virtual resections even with strict control for the height and weight of the patients. The angle between the patellar ridge and the patellar long axis was 11.24° ± 3.62°. The angle in male patients was 10.17° ± 4.82°, and it was 12.28°± 3.78° in female patients. The morphological difference was statistically significant (P < 0.05). After using the subchondral method to virtually resect the patellae, with reference to the center of the patellar cut, the center of the patellar ridge lies superiorly and medially in 88.75%, inferiorly and medially in 8.75%, laterally and superiorly in 2.5%, and in no case laterally and inferiorly. The intra-observer reliability regarding the dimensional measurements was excellent in this study.ConclusionsAdvances in 3D computer models had resulted in the availability of preoperative measurement and virtual planning. The anthropometric dimensions of this study could provide general information for guiding surgical management of the patella in total knee arthroplasty (TKA) and were useful in designing patellar implants.Clinical relevanceThe placement of the patellar component during TKA differs from one patella to another. The anatomic morphology information of the patellar ridge is helpful for surgeons to perform patellar resurfacing in TKA.