Abstract

Concentrated solar power plants using molten salts as heat transfer and storage fluid have emerged as the preferred commercial solution for solar thermal electricity in central receiver technology. Despite their ability to store large amounts of thermal energy and efficient receiver designs, further efficiency improvements are constrained by tight temperature restrictions when using molten salts (290 °C–565 °C). In this work, a novel heat transfer fluid based on a dense particle suspension (DPS) is used due to its excellent thermophysical properties that extend the operating temperature of solar receiver and allow its coupling with higher-efficiency power cycles. In this paper, the design of a DPS solar receiver working at 650 °C has been optimized for two commercial sizes (50 MWth and 290 MWth) coupled to an optimized subcritical Rankine cycle. The results showed that a five-extraction reheated Rankine cycle operating at 610 °C and 180 bar maximizes power plant efficiency when coupled with a DPS central receiver, giving 41% power block efficiency and 23% sun-to-electricity efficiency. For optimization purposes at design point conditions, in-house code programmed into MATLAB platform was used while TRNSYS software was employed for annual plant performance analysis.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.