Abstract
In-situ nanoscratch experiments were carried out on occlusal surface and axial section (on which axis is perpendicular to rods and axis parallels to rods, respectively) of human enamel using a sphero-conical indenter (∼1μm tip radius) at different normal loads. The elastic recovery and inelastic deformation during scratching process was evaluated in terms of three curves along the track: surface roughness, scratch depth, and post depth. Coefficient of friction (COF) and wear rate was addressed for the single rod. Results reveal that the amount of elastic recovery and inelastic deformation of a single rod on the axial section is more than that on the occlusal surface. At the enamel rod scale, COF depends on loads and locations. The wear resistance of a single rod on the occlusal surface is greater than that at direction of axis perpendicular to rods and axis parallel to rods. The load-dependence is attributed to the ploughing and pile-up. The location-dependence is ascribed to the angle change of normal loading direction, hydroxyapatite crystals orientation and the scratching direction. In addition, viscoelastic protein layers between the apatite crystals play an important role in the anisotropic wear behavior at microscale.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.