Abstract

One of the critical factors affecting the development of 3D concrete printing (3DCP) is the challenging issue of in-situ reinforcement. Engineered Cementitious Composites (ECC) are printable self-reinforced materials, and their application in 3DCP technology can facilitate de-steelisation. However, traditional ECC materials pose certain concerns for sustainable environmental development. The integration of Limestone Calcined Clay Cement (LC3) suitable for 3DCP into ECC (LC3-ECC) presents an ideal solution to the aforementioned challenges. Moreover, conducting comprehensive research into its size effects is an essential step from experimentation to engineering application. A thorough exploration of the size effects of 3D printed LC3-ECC in compression, shear, and flexural fracture aspects is conducted to derive size effect laws. The relationship between the anisotropic mechanical properties and size effects has been established. The mold-cast LC3-ECC precisely follows the Bažant size effect law (SEL). The fiber orientation effect enhances bridging efficiency, leading to the fact that the mechanical properties of certain printed LC3-ECC are hardly affected by the size effect. The mechanical performance of some printed LC3-ECC depends on interlayer strength, making its primary reason for size effect not in the Fracture Process Zone (FPZ) energy release, hence closer to the Multifractal Scaling Law (MFSL). LC3-ECC exhibits weak anisotropy in mechanical properties, showing satisfactory stability. However, under flexural fracture behavior, the anisotropic size effect is higher, necessitating careful consideration in structural design.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call