Abstract
A novel surface-corrugated superhydrophobic polyvinylidene fluoride (PVDF) membrane (C-PVDF) was prepared for direct contact membrane distillation (DCMD) using a micromolding phase separation (μPS) method. The membrane showed a static contact angle of 159.0 ± 4.0°. However, dynamic measurements of the sliding angles revealed a lower value of 9.1 ± 0.8° when a water droplet slides in parallel to the ridge, and a higher value of 14.6 ± 1.6° if perpendicular to the ridge. This anisotropic property was also reflected in the DCMD fluxes for both feed of deionized water and 4.0 wt% NaCl solution: in case the feed flows in parallel to the ridge, a higher flux is resulted than it flows perpendicular to the ridge. Anisotropic MD performance cannot be explained by the Dusty-Gas model because the average characteristics of the membrane in the model are intrinsically the same for both flow modes. Instead, anisotropic wetting and sliding in the parallel and perpendicular orientation revealed that the MD performance has both thermodynamic and hydrodynamic origins.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
