Anisotropic parameter identification using inhomogeneous tensile test

Abstract

In this contribution, an inverse identification strategy of constitutive laws for elastoplastic behaviour is presented. The proposed inverse algorithm is composed on an appropriate finite element calculation combined with an optimisation procedure. It is applied to identify material anisotropic coefficients using a set up of easy performed laboratory tests. The used experimental data are the plane tensile test and the off axes tensile tests. The identified behaviour models are mainly based on Hill's quadratic yield criterion. Two cases of this yield criterion have been considered: the transverse isotropic and the orthotropic one under an associated and non-associated flow rule assumptions for each case. The yield surface has been assumed to expand isotropically (isotropic strain hardening law) as a function of the plastic work. In order to better describe anisotropic plastic properties of the studied materials, a recently planar anisotropic yield function is used. It is a non-quadratic yield criterion which takes account of anisotropic yield stresses as well as anisotropic strain ratios. It is subsequently shown that the agreement between inverse identification results and experimental measurements were improved. We prove also that the presented strategy is a good alternative to the simplified homogeneous tests assumption, especially for the plane tensile test.