Abstract

ABSTRACTPolarized infrared reflectance from 300 to 1200 cm-1 at different incidence angles was measured at room temperature for sapphire and GaN/sapphire samples. A film of GaN was grown approximately 1.5 μm thick on c-plane sapphire by MOCVD with a thin GaN buffer layer. Because of the hexagonal structure of sapphire and GaN, their uniaxial optical properties are anisotropic. In the p-polarized reflective spectrum, we observed the mixed effect between the distinct infrared-active modes with dipole-moment oscillation perpendicular (E-mode) and parallel (A-mode) to the c axis. The contribution of the A-mode increased with increasing incidence angle. Therefore, we were able to obtain simultaneously the infrared dielectric functions parallel and perpendicular to the c axis, by fitting simultaneously three polarized reflectance spectra at three different incident angles with a suitable model. In the procedure, we adopted a new fitting technique, i.e., fitting the first numerical derivative of the polarized reflectance spectra to improve the accuracy of the phonon parameters and to overcome the inconsistency between the model and measurement in the whole frequency range. Excellent agreement has been obtained between the measured and fitted first derivative reflectance spectra for both the sapphire and GaN/sapphire samples. The dielectric information thus obtained for sapphire and GaN is of greater accuracy than those reported previously.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.