Anesthetic requirements measured by bilateral bispectral analysis and femoral blockade in total knee arthroplasty

Abstract

A continuous peripheral nerve blockade has proved benefits on reducing postoperative morphine consumption; the combination of a femoral blockade and general anesthesia on reducing intraoperative anesthetic requirements has not been studied. The objective of this study was to determine the relevance of timing in the performance of femoral block to intraoperative anesthetic requirements during general anesthesia for total knee arthroplasty. A single-center, prospective cohort study on patients scheduled for total knee arthroplasty, were sequentially allocated to receive 20mL of 2% mepivacaine throughout a femoral catheter, prior to anesthesia induction (Preoperative) or when skin closure started (Postoperative). An algorithm based on bispectral values guided intraoperative anesthetic management. Postoperative analgesia was done with an elastomeric pump of levobupivacaine 0.125% connected to the femoral catheter and complemented with morphine patient control analgesia for 48hours. The Kruskall Wallis and the chi-square tests were used to compare variables. Statistical significance was set at p<0.05. There were 94 patients, 47 preoperative and 47 postoperative. Lower fentanyl and sevoflurane were needed intraoperatively in the Preoperative group; median values and range: 250 (100-600) vs 450 (200-600)μg and 21 (12-48) vs 32 (18-67)mL p=0.001, respectively. There were no differences in the median verbal numeric rating scale values 4 (0-10) vs 3 (0-10); and in median morphine consumption 9 (2-73) vs 8 (0-63)mg postoperatively. A preoperative femoral blockade is useful in decreasing anesthetic requirements in total knee arthroplasty surgery but no added effect in the postoperative analgesic control.