Anatomy of the Insertion of the Posterior Inferior Tibiofibular Ligament and the Posterior Malleolar Fracture.

Abstract

Our aim in this study was to identify the extent of the posterior inferior tibiofibular ligament (PITFL) insertion on the posterior tibia and its relation to intra-articular posterior malleolar fractures. Careful dissection was undertaken on 10 cadaveric lower limbs to identify the ligamentous structures on the posterior aspect of the ankle. The ligamentous anatomy was further compared with our ankle fracture database, specifically posterior malleolar fracture patterns, demonstrating a rotational pilon etiology (Mason and Molloy type 2A and B). Computed tomography imaging was used to measure the dimensions of the fracture fragments. The superficial PITFL was found to have a transverse component and an oblique component. The average size of the tibial insertion was 54.9 mm (95% CI, 51.8, 58.0) from joint line and 47.1 mm (95% CI, 43.0, 51.2) transverse. From our database of ankle fractures involving the posterior malleolus, 80 Mason and Molloy type 2 fractures were identified for analysis. Of these, 33 were type 2A and 47 were type 2B. The posterolateral fragments had an average size of 26.3 mm (95% CI, 25.0, 27.7) height and 22.1 mm (95% CI, 21.1, 23.1) width. The posteromedial fragments had an average size of 22.0 (95% CI, 18.9, 25.1) height and 19.8 (95% CI, 17.5, 22.0) width. The superficial PITFL insertion on the tibia is broad. In comparison with the average size of the posterior malleolar fragments, the PITFL insertion is significantly larger. Therefore, for a posterior malleolar fracture to cause posterior syndesmotic instability, a ligamentous injury must also occur. Posterior syndesmotic instability results from injury to the PITFL. It has been widely reported that a posterior malleolar fracture will also give rise to posterior syndesmotic instability due to the insertion of the deep PITFL on the posterior tibia. On the contrary, in this paper, we have shown that the superficial PITFL insertion on the tibia is very large, much greater than the average size of the posterior malleolar fragments. Therefore, for a posterior malleolar fracture to cause posterior syndesmotic instability, a ligamentous injury will also have to occur.