Anatomical study of the technique of the axis laminar screws and development of guide

Abstract

PurposeTo develop a bidirectional slide guide to assist screw placement in the axial lamina and to preliminarily discuss the accuracy and feasibility of auxiliary screw placement.MethodsCT data from 40 randomly selected patients were imported into the software for modelling, and cross-pinning was used to simulate pinning. According to the different crossing methods of the upper and lower laminar screws, they are divided into two groups. In the software, the position of the needlepoint of each screw is accurately measured, and the needle point is kept unchanged to simulate the movable range of the screw tail under the condition that the body does not penetrate the cortical bone. The data were compared by grouping and gender. Finally, the guide was designed by combining the screw exit point and fine adjustment angle data of all patients with the centripetal principle of the slide rail.ResultsThe needle exit data L1/L2/L3/L4 were 6.44 ± 0.52 mm, 7.05 ± 0.48 mm, 3.55 ± 0.75 mm and 5.09 ± 0.74 mm, respectively, and the fine adjustment angle of the slide rail was 10.51° ± 0.87°. There was no significant difference between the two groups or between men and women (p > 0.05).ConclusionIn this experiment, using the data obtained from the simulation of screw insertion, a two-way slide guide was designed to assist the insertion of axial laminar screws. The guide locks the screw outlet point to position and guides the screw inlet point, which improves the accuracy and safety of screw placement.