Abstract
Modified Hopkinson pressure bar apparatus is widely used to investigate the dynamic fracture behavior of materials at higher rate loading. While using a small sample for fracture toughness testing, plane strain conditions are compromised. In the current work, a large diameter two-bar/ three-point bend fracture setup is used to analyze stress wave propagation behavior within a larger cracked specimen. The experimental setup model consists of striker, incident bar, loading pin, cracked three-point specimen, span and transmission bar. The model is prepared using ANSYS software and the transient dynamic analysis technique is used to simulate the dynamic load. The effects of increased transient time on the stress wave propagation behavior within the cracked sample and the stress and strain values at the crack tip of the three-point bend specimen are analyzed. In addition, the effects of the hollow striker, the hollow incident bar and the specimen span are studied. It is found that during large specimen testing, an increase in the transient time results in the lower stress and strain values in the specimen crack-tip. The relationship of the specimen span, the striker and the incident bars with the strain values in the specimen is analyzed and a method for the three-point bend specimen testing at the higher strain rates is also proposed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
