Abstract
The commercial Hexin Single particle aerosol mass spectrometer (SPAMS) has been widely used for environmental aerosol monitoring and source apportionment. However, particle size measurement is easily affected by environment pressure fluctuation and sampling orifice clogging. The capability for quantitative analysis is poor, and few isotope measurement has been reported. This paper aims to evaluate the analytical performance of SPAMS and extend its application. First, the flight time of standard particles having different densities and sizes was measured under various conditions (aerodynamic lens upstream pressure and carrier gas). We proposed a universal method for particle size calibration, measurement and correction, taking into account the effects of lens geometry (acceleration nozzle diameter), particle parameters (density, diameter, and shape factor), and operating conditions (lens upstream pressure and carrier gas). Then, isotope measurement was performed when introducing a solution droplet containing a single element. Metal oxide and metal cluster ions were observed in the mass spectrum, indicating incomplete ionization of the sample droplet. The mass discrimination effect was carefully evaluated to correct the measured isotope ratio. Results show that the achievable accuracy of the corrected isotope ratio for elements investigated was 5%. The instrumental performance was relatively poor for elements having great ionization potential or bond energy. Finally, Ag/Eu2O3 suspension and yellow cake/ethanol suspension were analyzed for size, elemental and isotopic analysis. We confirmed that the mass discrimination effect during suspension introduction could be corrected using the mass discrimination correction factor obtained during solution introduction. The Ag, Eu and U in these suspension particles were all found to be at natural abundance. The uranium in the yellow cake was identified as sodium duranyate (Na2U2O7) with volumetric equivalent diameter of approximately 65 nm. The work presented here is beneficial for instrument improvement and wide application.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.