Abstract
AbstractA systematic analytical method, based on the theory of screws, is presented for identification of limb structures of general and over‐constrained 3‐degree‐of‐freedom (DOF) translational parallel manipulators. Given a system of wrenches of constraint, the corresponding reciprocal basis screws are determined. Then, the joint screws of a limb are obtained by a linear combination of these basis screws. Feasible limbs that can be used for construction of translational platforms are enumerated according to the type of constraint and the number of joints making up the limbs. © 2004 Wiley Periodicals, Inc.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.