Abstract
Use of water-base coolant is a pre-requisite in an high speed grinding process to avoid thermal damage and to achieve better surface integrity as well as higher grinding ratio. However, the presence of hazardous chemical additives in the coolant causes environmental problems. As a result, stringent government legislation is being practiced for the coolant use and disposal, which consumes 7–17% of the total machining cost. This paper reports the coolant flux minimization through controlled jet impingement so as to prolong the coolant replenishment cycle. Control of coolant flux was achieved through development of a “metered quantity coolant” (MQC) nozzle which supplies the required amount of coolant to the grinding zone. Also, this investigation has shown that coolant velocity has a significant influence on the high speed grinding performance. When the coolant velocity is inadequate, coolant could not penetrate into the grinding zone. The increase in coolant velocity was realized with reduction in nozzle opening area and does not use a large quantity of coolant. This is of significance to reduce environmental pollution and machining costs through extended coolant replenishment period.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
