Abstract
The research presented in this paper is an experimental study and numerical analysis on mechanical behavior of the adhesively-bonded joint between FRP sandwich bridge deck and steel girder. Generally, there are three typical stress states in the adhesively-bonded joint: shear stress, tensile stress, and combination of both. To realize these stress states in the adhesively-bonded joint during tests, a specific loading device is developed with the capacity of providing six different loading angles, which are 0°(pure tension), 18°, 36°, 54°, 72° and 90°(pure shear). Failure modes of adhesively-bonded joints are investigated. It indicates that, for the pure shear loading, the failure mode is the cohesive failure (near the interface between the adhesive layer and the steel support) in the adhesive layer. For the pure tensile and combined loading conditions, the failure mode is the combination of fiber breaking, FRP delamination and interfacial adhesion failure between the FRP sandwich deck and the adhesive layer. The load-bearing capacities of adhesive joints under combined loading are much lower than those of the pure tensile and pure shear loading conditions. According to the test results of six angle loading conditions, a tensile/shear failure criterion of the adhesively-bonded joint is obtained. By using Finite Element (FE) modeling method, linear elastic simulations are performed to characterize the stress distribution throughout the adhesively-bonded joint.
Highlights
Fiber Reinforced Polymer (FRP) bridge decks are increasingly used in practice for rehabilitation of existing bridges and for new bridge constructions, which are due to the remarkable advantages of FRP decks: lightweight of bridge superstructures, ease of installation, minimum traffic disturbance, large tolerance for environmental corrosion, long service life, as well as low maintenance cost
Between FRP decks and steel girders, adhesive bonding is usually employed as a preferable connection method
According to failure loads of adhesive joints under the four combined loading conditions, the modified failure criterion of the adhesive joint is addressed by using aquadratic ellipsoid function, which is conservative and practical for the real application of an adhesive joint between FRP
Summary
Fiber Reinforced Polymer (FRP) bridge decks are increasingly used in practice for rehabilitation of existing bridges and for new bridge constructions, which are due to the remarkable advantages of FRP decks: lightweight of bridge superstructures, ease of installation, minimum traffic disturbance, large tolerance for environmental corrosion, long service life, as well as low maintenance cost. To be cost-effective, FRP decks are commonly supported by longitudinal main girders made of steel, prestressed concrete or FRP composites [1,2,3,4]. Between FRP decks and steel girders, adhesive bonding is usually employed as a preferable connection method. During the last two decades, the adhesive bonding technique was increasingly used in civil Engineering field, especially for repairing the deteriorated concrete components (beam and column) and structures using Carbon Fiber Reinforced Polymer (CFRP)
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
