Abstract
Enhancing the load capacity of aged and deficient thin-walled steel structures can be accomplished by increasing member stiffness in buckling prone regions. The literature shows that composite materials have become a major player in retrofitting applications. A new strengthening concept, Strengthening-by-Stiffening (SBS), is applied to buckling prone web panels in thin walled steel beams by bonding pultruded glass fiber reinforced polymer (GFRP) sections. The first part of present study is focused on the construction of a finite element (FE) model for accurate simulation of experimentally obtained results. Initial imperfections, material non-linearity, interlaminar fracture law to simulate adhesive debonding, and GFRP rupture or delamination are accounted for in the construction of the FE model. The second part of the study was focused on parametric studies using the validated FE model to investigate different GFRP sizes, contact areas, panel aspect ratio and slenderness of the web panels on steel beam with SBS retrofitting. Results from the parametric study were used to establish some limits to assist in SBS design. Finally, possible use of SBS strengthening method in new construction was investigated by substituting all steel stiffeners with bonded composite GFRP stiffeners for the improvement of fatigue related behavior that is known to start at the weld toes of steel stiffeners.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
