Abstract
Stamping dies for forming the cross-recessed heads of screws were implanted with various doses of 80keV nitrogen ions. The wear process during industrial production was studied by measurements of the evolution of wear land in the tool. An improvement by a factor of about 2.5 in the wear rate has been found. Tool chipping rate is reduced by a similar factor.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
