Abstract
Failures of multi-plate clutches must be reliably excluded due to safety-critical functionalities in the drive train. The main reason for failures of multi-plate clutches due to long-term and spontaneous damage is thermal damage. In this paper, a parameterizable two-dimensional finite element model is developed and validated for damage prevention and for analyzing the thermo-mechanical behavior of a clutch in transient operation. Both numerical verification and validation with experimental results are very good despite the simplifications in the model. Subsequently, the temperature and pressure distribution of the individual friction areas is determined. The results show that the maximum temperatures tend to occur at the outer diameter of the friction area. The pressure distribution is very homogeneous. In a parameter study, the influence of Young’s modulus of the friction lining, the thermal conductivity of the friction lining, and the steel plate thickness on the temperature and pressure behavior in the clutch is investigated. Although the Young’s modulus of the friction lining influences the pressure distribution in the friction contact, the temperature behavior is only slightly changed by the variation of the elastic modulus due to the load case. The thermal conductivity of the lining and steel plate thickness have a strong influence on the temperature level in the clutch. However, the distribution of pressures is still very homogeneous compared to the reference model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.