Abstract
During the assessment of the static strength of the flange connections elements Dn2130 and Dn2080 of the emergency cooling heat exchangers 08.8111.335 SB (TOAR), it was found that there is an excess of the allowable stress values. These calculations of static strength per formed using the finite element method (FEM). The analysis of the static strength of the flange joints was performed taking into account the design values of the tightening of the studs, equal to 22,527 kgf and 8,836 kgf, accordingly. At the same time, one of the main purposes of heat exchangers TOAR nuclear installation (NI) WWER-1000 is the work until accidents. The analysis of accidents of NI WWER-1000 showed that the largest values of change of parameters of environments in heat exchangers of TOAR correspond to accident “LOCA: Bilateral rupture of MCT”. Based on his, we considered the thermal stress state of heat exchangers for this accident. To determine the thermal stress state of the TOAR heat exchanger elements, during accidents of the nuclear installation, strength calculations were performed in the non-stationary formulation of the problem. One of the boundary conditions for these strength calculations is the distribution of temperatures along the thickness and length of the walls of the elements of the heat exchanger, which changes over time. Numerical thermohydraulic calculations were performed to determine these boundary conditions. In the article for the first time the results of calculations of thermal stress state of separate elements of heat exchangers TOAR, for work of heat exchangers during accidents of nuclear installation are received. It is established that the elements of the flange connection Dn2130 are one of the most critical elements of TOAR heat exchangers. To determine the thermal stress state of the heat exchanger elements, analytical thermal calculations, numerical thermohydraulic and strength calculations were performed using the FEM method. As a result of the analysis of the performed strength calculations, it was concluded that it is necessary to reduce the tightening value of the flanges of the flange connection Dn2130 to 14600 kgf
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
