Abstract
AbstractThe packing stage starts at the end of mold filling. During this stage, additional material is forced into the mold to compensate for the shrinkage during subse‐quent cooling. Underpacking results in molded parts with dimensional variation. Overpacking causes flash at the parting lines, stick during ejection, and excess residual stresses resulting in warpage. The packing stage is thus extremely important in the determination of the final quality of the product. Despite its importance, analysis of the packing stage has been relatively ignored, particularly the viscoelastic effect. In this work, the analysis of the isothermal packing stage is presented for a Maxwell fluid. A set of governing equations is derived for a two‐dimensional mold and solved using the Galerkin finite element method. In addition to the distribution of velocity and pressure, the model predicts the stresses in the planar direction, which could be used for subsequent calculation of the residual stresses.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
