Abstract
Sealing of contained fluids is the primary performance required for pipe flange connections. It is well known that the leakage is likely to occur when contained fluids at high temperature are concerned. Due to the differential thermal expansion of each part, bolt preloads that tighten a pair of pipe flanges tend to decrease. Therefore, it is significantly important for the joint safety to estimate the amount of bolt preload reduction at the design stage. In this paper, a finite element approach is proposed to analyze thermal and mechanical behavior of pipe flange connections at elevated temperature, by incorporating the stress-strain curves of sheet gaskets measured in the previous paper. Then, the reduction rate of bolt preloads at elevated temperature is systematically evaluated. The analytical objects are pipe flange connections tightened with aramid sheet gaskets. When a pipe flange connection is subjected to thermal load, the gasket stress usually decreases along unloading curves. The temperature dependency of gasket stiffness is considered by defining Young’s modulus in unloading E*, which can be introduced into FE formulation using ordinary solid elements. Numerical results show that bolt preloads are decreased by as much as 30% of the initial value when using aramid sheet gaskets of 3mm thickness. The effectiveness of the proposed numerical method has been confirmed by comparing the numerical results of bolt preload reduction to experimental ones.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.