Abstract
The article presents an analysis of the turning parameters of two non-ferrous materials. The tested materials were: brass CuZn39Pb3 and aluminum alloy AW 6060. A Kyocera turning knife and a WNMG 080404 AH plate were used to make the samples. Three parameters were tested: rotational speed, feed and depth of cut at three levels of variability. The roughness parameters Ra and Rz were selected for the analysis. On the basis of the obtained results, it was shown that the feed used during machining has the greatest influence on roughness, while the change of depth or cutting speed does not cause significant differences in roughness.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
