Abstract
The article presents experimental data obtained by studying the influence of changes in the geometry of parts made of maraging steels, depending on the modes of thermal and thermal cycling treatment with heating in the temperature range of α-γ transformation. The experiments were carried out on samples cut from hot-rolled sheets, pre-hardened at a temperature of 1000°C for 1 hour. Using the accelerated testing method, the relative change in resistance to stress corrosion damage was determined depending on the phase composition and aging temperature (strength) of maraging steel.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
