Abstract
Whilst powder injection moulding (PIM) of metal or ceramic parts is a favourable technique for producing complex geometries, there are still limitations concerning undercuts, closed cavities or mobile connections. In this paper, a sinter-joining technique of stainless steel parts is presented using the example of a microcheck valve. The valve was produced by an automatic assembly of two powder injection-moulded housing parts and an incorporation of a ceramic ball during the assembly step. The subsequent sintering process allowed fusing single particles and densifying the check valve. To evaluate the quality of the joining step, the contact area was investigated microscopically, and internal pressure tests were performed. The results revealed that a dense contact area can be achieved by using suitable sintering parameters which in turn leads to internal pressure values higher than 700 bar.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.