Analysis of the influence of local electrodeposition conditions on the accuracy of electrochemical 3D-printing

Abstract

Problem. Additive manufacturing of metal parts by local electrodeposition is a new promising area with several unique features. The use of electrolysis makes it possible to manufacture metal parts at room temperature with high accuracy and low energy consumption. The accuracy and speed of electrochemical 3D printing are inversely related, and therefore it is important to find optimal electrodeposition conditions at maximum speed without degrading accuracy. The aim of the study. The purpose of this work was to analyse the influence of electrodeposition parameters (electrode distance, electrical conductivity and electrolyte polarization) on the accuracy of metal deposit formation in a computer model and to conduct experimental verification of optimal conditions for electroforming a real object from copper sulphate electrolyte. Methodology of implementation. To achieve the goals of the study, computer simulation of the electrochemical deposition process in the COMSOL Multiphysics software and electrochemical measurements of the characteristics of copper sulphate electrolytes were used. Research results. Computer simulation established optimal conditions: the distance between the edge of the capillary and the surface on which deposition occurs is not more than 0.5 mm, the electrolyte in which the inverse slope of the cathode polarization curve is not lower than 2000 mA/(V×cm2) and the electrical conductivity is not higher than 0.02 S/сm. The influence of the electrolyte composition on the inverse polarization of the cathode process and its electrical conductivity was investigated. The optimal composition of the electrolyte was selected, containing 200 g/L CuSO4, 60 g/L H2SO4, 0.2 g/L KCl and RUBIN T-200 additive. In the selected electrolyte, the value of the inverse slope of the cathode polarization curve is 2120 mA/(V×cm2). Verification of the process of local electrodeposition in the selected electrolyte during the electroformation of a cylindrical object with a diameter of 4 mm and a height of 100 μm was carried out. It was determined that no more than 5 % of metal was deposited outside the capillary of the working electrode. Conclusions. The results of the work can be used to create an electrochemical 3D printing system. Further research should be aimed at approbation of the obtained parameters of local electrodeposition in an installation that simulates the operation of a 3D printer and establish the accuracy and speed of printing of a three-dimensional object. Key words: additive manufacturing, electrical conductivity, electrolyte composition, polarization, local electrodeposition.