Abstract
The utilization of aluminium wires is widespread in the electrical energy transmission industry as well as in various other applications. Wire drawing are used to decrease the diameter of the wires. Simulations are conducted utilizing simulation software to imitate the drawing process of a 2.6 mm diameter Aluminium wire and reducing it to 2.2 mm through both conventional drawing methods and simulation that includes excitation of ultrasonic stimulation. The study of adding ultrasonic stimulation focuses on two critical elements, the draw force and its impact on the energy consumption during the drawing process, and the stress induced on the aluminium wire. The results of the simulation demonstrate a reduction in both the energy consumption and the stress levels on the Aluminium wire as a result of incorporating ultrasonic technique in stimulation of the drawing process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Advanced Research in Engineering Innovation
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
