Abstract
Recently, pattern collapse is becoming one of the critical issues in semiconductor manufacturing and many works have been done to solve this issue 1 ) 2 ). Since pattern collapse occurs when outer force onto the resist pattern such as surface tension, impact of rinse solution, etc. surpasses the resistance of the resist pattern such as mechanical strength, adhesion force between resist and substrate, it is considered effective for improvement of pattern collapse to control resist film properties by track process, i.e., optimization of the mechanical properties of the resist film and enhancement of the adhesion force between resist and substrate 3 ) -5 ). In this study, we focused on the mechanical strength of the resist film and examined how post applied bake (PAB) condition affects the pattern collapse behavior. From ellipsometry measurement, it was found that increasing PAB time and temperature resulted in thickness reduction and refractive index increase, which suggested that the density of the resist film became high. Then we analyzed the mechanical strength of the resist film with the tip indentation method using atomic force microscope. It was found that the hardness of the resist film was affected by PAB conditions and regardless of PAB condition, hardened layer existed beneath the film surface. Finally, we carried out the measurements of loads to collapse 180nm resist dot patterns using the direct peeling with atomic force microscope tip (DPAT) method. Loads ranged from 600 to 2000nN overall and essentially increased as seen for indentation measurements when PAB temperature or time was increased, except some critical conditions. Through these evaluations using AFM, we succeeded in quantitatively evaluate the mechanical properties of the resist films processed with various PAB conditions. It was found that PAB condition obviously impacts on the hardness of the resist film and it is closely related to pattern collapse load.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have