Abstract

This work is aimed at studying the influence of various components’ content on the process of vacuum dehydration. It was found that with an increase in the proportion of fat in dry matter from 10 to 20 %, the duration of disinfection increases by 4 %. The further grows of the fat proportion from 20 to 50 increases the process duration by 54 %. It was revealed, when cheeses, with the fat proportion equal from 10 to 50 %, a change their fat proportion by 1 %, the duration of dehydration decreases by 4.25 minutes, and the drying rate grows by 0.0065 %/min. It has been discovered that with an increase in the table salt concentration with the same mass fraction of cheese moisture 53–55 %, a decrease in the rate of dehydration is observed as well. In the period with a constant drying rate at a concentration of sodium chloride of 1 %, the drying speed is 0.98 %/min; 2 % – 0.8 %/min; 3 % – 0.72 %/min; 4 % – 0.54 %/min. The amount of water activity in cheeses was investigated. It was established that with an increase in the concentration of table salt from 1 to 4 %, the water activity of cheese before drying changes by 0.131; after drying – by 0.174.

Highlights

  • Improving the existing technologies and developing new effective ones for processing agricultural raw materials has always been one of the urgent tasks of the food industry [1–10]

  • As for dairy products, cheese occupies a special place. The uniqueness of this product lies in its special chemical composition, which includes a whole range of biologically active components that have a beneficial effect on human health [11–16]

  • Factors influencing the vacuum drying process are the modes of the drying unit itself, as well as the geometric characteristics of the product itself and its physicochemical composition [26–31]

Read more

Summary

Introduction

Improving the existing technologies and developing new effective ones for processing agricultural raw materials has always been one of the urgent tasks of the food industry [1–10]. As for dairy products, cheese occupies a special place. The uniqueness of this product lies in its special chemical composition, which includes a whole range of biologically active components that have a beneficial effect on human health [11–16]. One of the possible ways of preserving and processing this type of material is vacuum dehydration. Factors influencing the vacuum drying process are the modes of the drying unit itself (heating temperature, method of supplying heat, residual pressure, etc.), as well as the geometric characteristics of the product itself and its physicochemical composition [26–31]

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call