Abstract

Aim.The research was conducted for the study of the adhesion of samples of the domestic modern photopolymerizable base composite material in comparison with other materials for the manufacture of the denture bases.Materials and methods.Five samples of the materials were tested to conduct a microbiological study on the subject of primary adhesion of microorganisms to the surface of the base materials. The adhesion of microorganisms to the samples of the base composite materials was assessed using the index method.Results.As a result of a laboratory research, it can be concluded that the new photopolymerization material «Sample 1» used for the manufacture of the bases for the removable dentures has 1, 19 times lower adhesive activity to the colonyforming Prevotella intermedia microorganisms and Candida krusei mushrooms in comparison with the acrylic plastics and thermoplastic materials «Sample 2»; 1,14 times in comparison with the nylon material «Sample 3» and with the monomer material «Sample 4» with a statistically reliable variable number. It should be noted that the Axil-LC topcoat varnish supplied with the Sample 1 basic material kit increases microbial adhesion by 1.36 times.Conclusion.The adhesion of microorganisms to the materials that are used in dental practice is due to the surface tension coefficient – the greater the surface tension coefficient, the higher the probability of adhesion of microorganisms on the surface of these materials. The investigated new photopolymerization material «Sample 1» without coating with a protective varnish showed low adhesion to all major pathogens. Covering with a protective lacquer design, which is a part of the set of the material, significantly increases the adhesion of microorganisms on the surface of the material. The established indexes of microorganisms adhesion to the material «Sample 1» allow us to recommend it for the manufacture of bases for temporary dentures and immediate dentures in the treatment at the stages of dental implantation.

Highlights

  • Five samples of the materials were tested to conduct a microbiological study on the subject of primary adhesion of microorganisms to the surface of the base materials

  • The research was conducted for the study of the adhesion

  • it can be concluded that the new photopolymerization material

Read more

Summary

Introduction

Five samples of the materials were tested to conduct a microbiological study on the subject of primary adhesion of microorganisms to the surface of the base materials. Porphyromonasgingivalis дования на предмет первичной адгезии микро- высокий уровень адгезии продемонстрировал к организмов к поверхности базисных материалов материалу «Образец 4»: 0,66±0,04. Адгезия этобыли проведены испытания 5 (пяти) образцов го патогена к нейлоновому полимеру «Образец материалов: «Образец 1» («ВладМива») – без 3» и термопластичному «Образец 2» оказалась покрытия покрывным лаком «Аксил-LC»; «Обра- достоверно ниже: по 0,50±0,04 к каждому.

Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call