Analysis of Surface Patterns and Electric Field Simulation of Antireflective Green Lacewing Wings.

Abstract

The structural coloration and decoloration are problems of scientific interest for a long time. Hence, the fundamental investigations on structures and the optical properties of insect wings have been performed. As a part of such studies, we elucidate the optical properties of green lacewing wings via observation and simulation. First, we elucidate the surface pattern of green lacewing wings using a two-dimensional fast Fourier transform. A cross-shaped pattern of a Fourier spectrum is obtained, and the concise wing model with the surface protrusions arranged in a square grid on a base substrate is constructed in reference to the obtained Fourier spectrum. Next, we perform a finite-difference time-domain (FDTD) simulation to elucidate a light path through wings with and without surface protrusions. The FDTD simulation results indicate that the surface protrusions of a wing increase and decrease the intensity of the transmitted and reflected light, respectively, which is an antireflection behavior. This phenomenon was also observed in the case of 45° incident light. The intensity of transmitted light coupled to wings is induced by surface protrusions with a stepwise refractive index between air and a substrate, which induces antireflection. In particular, transmitted light is increased by the surface protrusions of wings in the range of 500-800 nm wavelength. The intensities of transmitted and reflected light are affected by the direction of incident electric field (polarization) in the case of wings with protrusions arranged in the same direction (parallel). Hence, the surface protrusions are arranged in a square grid to reduce the influence of the polarization direction.