Abstract
Abstract High-speed and high-frequency PCB interconnect solutions with the slightest discontinuities in the physical geometry along the microstrip transmission line can significantly degrade the integrity of the signal being transferred. This paper presents an analysis of SMT component pads and their impact on the successive transmission line impedance. During 0805, 1206 and 2512 package size SMT component pad discontinuity evaluations it was spotted, that the increasing deviation from target impedance affects the microstrip impedance segment following the discontinuity. A 25 Ω impedance offset at the SMT pad reduces the line impedance afterwards by up to 7 Ω. A 37 Ω impedance offset results in a microstrip impedance reduction by up to 15 Ω, whereas a 45 Ω impedance change leads to a reduction of successive segment impedance by up to 30 Ω. This effect is also present in multiple evenly-spaced discontinuities. But a single reference plane cut-out, which is twice as wide as the SMT component discontinuity, substantially improves the overall impedance of the transmission line, including the successive line segment impedance drop.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
