Abstract
Shrinkage in a molded plastic part is important in defining finishing measurements of the part. In this paper it has been tried to find effect of the injection pressure, Gate sizes and cooling system that plays on the shrinkage rate of a ABS component in automotive components during injection molding process. Finite numerical solution was used to find the solution for the physical model. Molding is widely used for producing parts in large volumes it can be used for producing complex parts and can be produced with minimum effect. Still, the setting of the process parameters has to be optimized otherwise there will be defects caused due to the process parameters, such as shrinkage. In this paper, it is tried to optimize the molding process in order to reduce the molding defects like shrinkage by using Taguchi’s experimental design and the analysis of variance (ANOVA) methods
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
