Abstract
Application of a two-phase slug flow in side-stream membrane bioreactors (MBRs) has proven to increase the permeate flux and decrease fouling through a better control of the cake layer. Past literature has shown that the hydrodynamics near the membrane surface have an impact on the degree of fouling by imposing high shear stress near the surface of the membrane. Previously, shear stress histograms (SSH) have been introduced to summarize results from an experimental setup developed to investigate the shear stress imposed on the surface of a membrane under different two-phase flow conditions (gas and liquid) by varying the flow of each phase. Bimodal SSHs were observed, with peaks corresponding to the shear induced by the liquid and gas flow respectively. In this contribution, SSHs are modelled using simple empirical relationships. These are used to identify the two-phase flow conditions that optimize fouling control. Furthermore, the total energy consumption of the system was estimated based on the two-phase pressure drop. It was found that low liquid and high gas flow rates (ratio of approx. 4) balanced the peaks and minimized the energy consumption.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
