Analysis of Pristine and Tcnq-Loaded MOF FILMS By Contactless Microwave Dielectric Spectroscopy Technique

Abstract

Metal-organic frameworks (MOFs) are porous and crystalline Coordination Network Compounds (CNCs), also referred to as porous coordination polymers (PCPs), which consist of inorganic metal (or metal/oxo) clusters connected by organic linkers. Surface Anchored Metal-organic-framework (SURMOF) films consist of quasi-liquid phase epitaxially grown highly ordered crystalline MOF films. For this study we used MOF Cu3(BTC)2 (BTC: benzene tricarboxylate) films, also known as HKUST-1 (Hong Kong University of Science and Technology-1), which were infiltrated with tetracyano-quinodimethane (TCNQ) guest molecules to modulate the charge transport characteristics. HKUST-1 MOF thin films have been grown using a liquid phase epitaxy (LPE) spray method in which the metal-containing solution [1 mmol Cu(OAc)2] and the linker solution [0.1 mmol BTC] are sprayed alternately on modified silicon substrates. Subsequently, the samples were immersed into an ethanoic TCNQ solution.We report on localized charge transfer processes at microwave frequencies of porous metal-organic framework (MOF) HKUST-1 Cu2(BTC)3 samples. As part of this study we will compare measurements done in the HKUST-1 pristine form of the material with open pores and HKUST-1, where the pores have been infiltrated with tetracyano-quinodimethane (TCNQ), resulting in a hybrid structure with enhanced electrical conductivity and a significant measurable effect in the microwave propagation characteristics [1]. We present data and analysis from an evaluation of pristine and loaded HKUST-1 SURMOF films using the contactless broadband microwave dielectric spectroscopy (BDS). The technique enables the accurate operando evaluation of the electrical and magnetic properties of materials without compromising the kinetic conditions of the experiment. The BDS method is uniquely suitable for investigating charge transfer reactions, regardless of the nature of the charge carriers, i.e., electrons and holes [2]. As such, these material state-sensitive parameters could be used to monitor charge transfer changes in the SURMOF and SURMOF-TCNQ hybrid analytes.[1] G. M. Espallargas and E. Coronado, “Magnetic functionalities in MOFs: from the framework to the pore”, Chem. Soc. Rev., 2018,47, 533, DOI: 10.1039/c7cs00653e[2] A. M. Wernbacher et al, Operando Electrical Conductivity and Complex Permittivity Study on Vanadia Oxidation Catalysts, J. Phys. Chem. C 2019, 123, 8005−8017, DOI: 10.1021/acs.jpcc.8b07417