Abstract
In order to realize the continuous power supply for the vibration fault monitoring system of automobile engine, aiming at the low efficiency and instability of the existing piezoelectric full bridge rectifier energy collection circuit, this paper proposes a circuit scheme based on synchronous charge extraction. The scheme can provide circuit collection efficiency, and analyze the power of the circuit by impedance analysis. Finally, the experiment shows that the theoretical analysis is consistent with the experimental results. And the synchronous electrical charge extraction circuit can harvest power up to 1.3mW under low frequency conditions, which is higher than 0.5mW collected by the full-bridge rectifier circuit under the same conditions. The harvested energy meets the power requirements of automotive sensors and microcontrollers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
