Abstract
Oxygen gas, water used to humidify the gases, and surface oxides originated from the carbon black and catalyst preparation are the three possible oxygen sources contributing to carbon support corrosion (CSC) at the cathode in proton exchange membrane fuel cells (PEMFC). To discriminate among them, oxygen was isotopically labeled by replacing regular water with oxygen-18 ( 18O) enriched water (H 2 18O, 98%) in differential electrochemical mass spectrometry (DEMS). The DEMS spectra of the cathode exhaust gases O 2, O 18O, 18O 2, CO 2, CO 18O and C 18O 2 ( m/ z equal to 32, 34, 36, 44, 46 and 48 correspondingly), sampled by a mass spectrometer during cyclic voltammetry (potential cycled for 100–1400 mV at the rate of 10 mV s −1) and chronoamperometry, were analyzed to identify the sources of oxygen, identify mechanistic pathways, and classify the surface oxides on carbon for CSC. It was found that water is the main direct oxygen source for CSC. Water reacts with carbon to produce at least three types of carbon surface oxides, which are then further oxidized with water to produce CO 2 in different potential ranges.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
